Traveller PlusUser GuideP2315_R01e.qxd 11/7/2003 12:59 PM Page 1
1716InstallationInstallationLap Belt Only Installation• Figure A illustrates a typical lapbelt only installation. •When not in use, always store theLA
1918Versa-Tether®Versa-Tether®WARNING:•ATTACH THE VERSA-TETHER ONLY TO TETHER ANCHORSIDENTIFIED BY YOUR VEHICLE MANUFACTURER AS TETHERANCHORAGE POINTS
2120Using Restraint FeaturesPad InsertsThe pad inserts are designed to beadjusted to offer the child more or lesssupport as needed.The two flat pads a
2322Using Restraint FeaturesBuckle Fastening the Buckle1 Hold the buckle with one hand.2 Use your other hand to insert onetongue at a time into the bu
Securing Your ChildSecuring Your ChildOnce the restraint has been installed inthe vehicle, follow these instructions tosecure your child in the restra
Adjusting Buckle Position The buckle has two positions andshould be adjusted to fit your child (Fig. D). Select the slot closest to, butnot under, the
2928Care and MaintenanceCare and MaintenanceCover Removal 1 Loosen the harness, by lifting the harness adjuster while pulling theshoulder straps forwa
3130Care and MaintenanceCare and MaintenanceCleaning the BuckleIf your child eats and drinks whilein the restraint, you may need tocheck the buckle pe
32WarrantyThis restraint was distributed by SnugSeat®. SnugSeat warrants this product to the originalpurchaser as follows:LIMITED ONE-YEAR WARRANTY T
Table of ContentsSafety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–5Features . . . . . . . . . . . . . . .
32•Use only with children who weigh between 22 and 105 pounds(10 and 48 kg) and whose height is 56 inches (142 cm) or less.•Snugly adjust the belts pr
54Safety InformationSafety Information• This child restraint system conforms to all applicable Federalmotor vehicle safety standards. This restraint i
76FeaturesFeatures123456789101213111 Head Pad2 Cover3 Harness Retainer4 Harness Slots5 Comfort Pads6 Chest Clip7 HUGS™ Shoulder Pads8 Buckle9 Pommel10
8Vehicle Seating PositionsVehicle Safety BeltsNOTE: The information in this section onlyapplies to installation with vehicle seatbelts. IMPORTANT: Som
10 11InstallationLATCH Installation1Verify that your vehicle isequipped with LATCH anchors(Fig A).• If LATCH anchors are notinstalled,you must use sta
13Installation4Route the vehicle belt aroundthe back of the restraint thenthrough the second belt slot,from the rear of the restraintto the front (Fig
15144Route the vehicle belt underthe cover then through thesecond belt slot, from thefront of the restraint to therear (Fig. C).5Verify that the vehic
Comments to this Manuals